AGFA SNAPSCAN 600 User Manual download pdf (Page 37)

Chapter 3 — Installing the scanner for the PC 37

Testing the connection

You are now ready to perform a test to check if the scanner is correctly connected

to your PC.

Caution: Check if the scanner is properly unlocked .

1. Connect the power cord to the scanner.

Use the correct power cord for the voltage in your area. SnapScan

automatically adjusts to any AC electrical outlet rated from 100V to 240V.

2. Check if the SCSI cable is properly connected.

3. Switch on the scanner.

The scanner performs a self-test during which the status indicator blinks

slowly. This takes about 15 seconds or less. After the self-test the status

indicator remains on.

If a malfunction is detected during the self-test, that is, if the status indicator

starts blinking at a higher frequency, refer to

Appendix C, “Troubleshooting” .

4. Switch on any other SCSI devices you may have attached, and wait for them

to start up.

5. Switch on your PC.

6. Check in the Adaptec™ SCSI interrogator if the SCSI interface card sees the

scanner at the right SCSI ID. You will find the SCSI interrogator after installing

the software EZ-SCSI. For more information see

Choosing a SCSI ID in the computer

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 71 72

No comments

AGFA SNAPSCAN 600 User Manual Page 37