AGFA SNAPSCAN 600 User Manual download pdf (Page 18)

Chapter 2 — Installing the scanner for the Macintosh computer 18

Connecting the scanner

A SCSI cable is supplied with your scanner.

Caution: For safety reasons, never use extension cables for power cords.

Always make sure there is only one terminator in your SCSI chain. You put the device

with the terminator at the end of your SCSI chain. Some SCSI devices, such as the

external hard disk, have built-in terminators and must therefore be placed at the end of

your SCSI chain. Check the documentation of each of your SCSI devices if you are not

sure whether the device has a built-in terminator. The last device of your chain has to be

terminated. Your SnapScan has no built-in terminator. (For more information see

SCSI devices .)

If your SnapScan is the only SCSI device to be connected to your

computer

1. Switch off your scanner and disconnect the power cord.

2. Switch off your computer and disconnect the power cord.

3. Connect the smaller 25-pin end of the SCSI cable to the connector on your

computer.

4. Connect the larger 50-pin end of the SCSI cable to the connector on your

scanner.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 71 72

No comments

AGFA SNAPSCAN 600 User Manual Page 18